Can’t access mywifiext setup page using 192.168.1.250? Need not to worry! With the troubleshooting tips mentioned in this post, you can easily fix 192.168.1.250 not working issue from the comfort of your home. Let’s get started!
Fixed: 192.168.1.250 Not Working
We advised you follow the troubleshooting tips outlined underneath correctly one by one. As soon as you find the culprit behind 192.168.1.250 not working issue, it will become a piece of cake for you to resolve the issue. Continue reading!
Check for Input Error
Many users make typing errors while typing 192.168.1.250 IP address, making it non-working. So, cross-check the IP address after typing it. Also, if you are entering the IP address in the browser’s search bar, then also you will not be able to access it.
Apart from that, if you are using any of the below-mentioned addresses, then also 192.168.1.250 not working issue will continue to appear:
- www.192.168.1.250
- 192.168.1.25o
- http//192.168.1.250
- 192.168.1.250.com
- 192,168.1.250
- 192.168.1.250.net, and so on.
The correct IP to access the Netgear extender setup page is 192.168.1.250. However, it is suggested to enter it carefully. Otherwise, you will be redirected to some other website instead of the mywifiext setup page.
Check the Power and Ethernet Connection
- Make sure that your Netgear extender is receiving continuous and uninterrupted power supply. If the power being supplied to your device is not steady, then you may face various technical issues with it.
- Besides, ensure that your extender is properly connected to your router using an Ethernet cable. In the event that the wire you are using is worn out, then many technical faults with your device can appear.
Once you are done with this troubleshooting tip, connect your computer or laptop to Netgear_Ext, and try to access Netgear extender setup page using 192.168.1.250 again. We hope that, this tip will help you out to fix the issue in no time. Just in case, the same issue continues to persist, head over to the next fix.
Temporarily Disable the Firewall Security
On the off chance if the troubleshooting steps listed above failed to resolve the issue for you, then the culprit can be the firewall security installed on your device. Sometimes, the antivirus software or the firewall security can stop you from accessing 192.168.1.250. In order to get the issue fixed, we suggest you temporary disable the firewall security on your device prior to accessing 192.168.1.250.
Opt for the Extender’s Default Web Address
Chances are that the default IP address of your Netgear WiFi range extender has been changed. Well, in that case, we suggest you to use the extender’s default web address, i.e. www.mywifiext.net.
The web address works in the same manner as that of 192.168.1.250 IP. All you need to do is to connect your WiFi-enabled devices to Netgear_ext, open a web browser of your choice, and enter the web address in the URL bar. Doing so will take you to Netgear Genie setup page, where you can change your device’s default settings as per preferences.
Still the Same?
If the “192.168.1.250 not working issue” remains the same even after following the fixes listed above, then the only way to troubleshoot it is to reset your Netgear WiFi range extender back to the default factory settings.
In order to reset your device, follow the instructions given below:
- Disconnect all the devices that are connected to your Netgear WiFi range extender (wired or wirelessly).
- Once you’re done, locate the reset hole on your device.
- As soon as you find the reset hole, press it gently using a pin, paper clip, or oil pin.
- Release the reset hole after holding it for a couple of seconds.